The PB OR1 built for the Toyota Land Cruiser 250, 2024 onwards, in 18 inch, 20 inch and 22 inch. A single piece monoblock forging, machined to this car's own hub rather than adapted to fit it, so there are no spacers and no adapters.

Fits

Toyota Land Cruiser 250 Series, 2024 onwards, the generation sold in the UK from 2024. Invincible and First Edition, with the 2.8 litre turbodiesel.

The 250 runs 6x139.7 with a 95.1 mm centre bore on studs and M14 x 1.5 lug nuts. This listing is for the 250 Series only. If you have an earlier Land Cruiser, tell us the year and we will confirm the fitment before anything is quoted.

Sizes

Choose 18 inch, 20 inch or 22 inch. All three run square on this car, four wheels the same width front and rear. The factory fits 18 inch on the First Edition and 20 inch on the Invincible, so 22 inch is the upgrade and the largest we build for it.

Fitment

• Bolt pattern: 6x139.7
• Centre bore: 95.1 mm, machined to the hub
• Fasteners: studs and lug nuts, M14 x 1.5
• Wheel torque: confirmed on the fitment sheet
• Factory sizes on this car: 18 and 20 inch, square

Offsets are set per size when we build the set. We work to the car, not to a catalogue number.

What you get

• A set of four, forged and finished to order
• Your choice of size from 18 to 22 inch
• Finish and colour chosen with you before anything is cut
• Design proof before cutting, two revisions included
• Lifetime structural warranty
• Free UK delivery, fully insured

Lead time

6 to 8 weeks from the day you approve the design proof.

Changed your mind

Tell us any time before we start cutting and you get a full refund. Once machining begins the set is made to your car alone and cannot be resold, so we are not able to refund it after that.